spitfires
[Top] [All Lists]

RE: Light Gaskets

To: Joe Curry <spitlist@gte.net>, Ken C <KenCunningham@worldnet.att.net>
Subject: RE: Light Gaskets
From: "Bowen, Patrick A" <PABowen@sar.med.navy.mil>
Date: Fri, 20 Aug 1999 08:13:42 -0400
Joe, I have been waiting for someone to ask about this.  I am the one that
took the project on but have unfortuneatly been shut down at every turn.
The last company I talked to wanted $6000 for the machining and $25 a piece.
I am still working the issue.  Does anyone on the list know of a good
specialty rubber molding company I could try?

Thanks,
Patrick Bowen

-----Original Message-----
From: Joe Curry [mailto:spitlist@gte.net]
Sent: Thursday, August 19, 1999 5:22 PM
To: Ken C
Cc: spitfires@autox.team.net
Subject: Re: Light Gaskets



Ken, If you are talking about those Rubber Marker plinths (that the
pieces fit into, they are no longer available.  However someone on the
list a while back was going to see about having new ones molded again.

I haven't seen any announcements, but perhaps it is in the works.

Anybody??????

Joe

Ken C wrote:
> 
> Spitmaniacs,
> 
> Any good sources for gaskets ? In particular, the left, right, front, rear
> (4 gaskets) for the side marker lights for a '72 Spit. Also need the
number
> plate (license plate) light gasket for the same car.
> 
> Most of the rest of the gaskets can be locally fashioned, the above would
be
> difficult to make.
> 
> TIA,
> 
> Ken C

-- 
"If you can't excel with talent, triumph with effort."
 -- Dave Weinbaum in National Enquirer


<Prev in Thread] Current Thread [Next in Thread>