I shim up the rear springs with nylon sheet. I cut a square about
1/4" thick the width of the spring leaf, drill a hole in the centre of
it.
Then I put a bolt through the hole, and chuch it in a lathe,
and machine down most of the square, leaving a circle raised in the
centre. I think It's about 3/4" diameter. This fits up into the dimple
at the ends of each spring leaf. Been driving on these for 6 years.
Cheers, Fred
--
Fred & Wendy Griffiths
Calgary, Canada
mailto: griffco@cadvision.com
http://www.cadvision.com/griffco/index.htm
|