> I'm replacing the head bolts on my SBC with ARP studs.
> With the cap screws I used ARP's sealant (the bolts holes
> open into the water jacket). I'd like to Loctite the studs in place
> but not sure which produce to use. On the mains I used #262 (red)
> but #271 "locks and seals (Enco catalog page 917) so I'm thinking this
> may be a better choice - the catalog continues "...bearing retaining nuts,
> cylinder liner studs, door closer plugs, ..." Any recommendations?
> Sure was easier when all they had was "Nutlock" and Studlock"!
I'd call Loctite or send them an email.
Suggested annual donation $12.96