| To: | Don Malling <dmallin@attglobal.net> |
|---|---|
| Subject: | Re: Patching an oil pan |
| From: | Paul Parkanzky <parkanz1@msu.edu> |
| Date: | Wed, 3 Aug 2005 00:22:39 -0400 |
I have successfully used JB Weld for this on a car that we couldn't buy a new oil pan for. Drain the oil. Clean it up the best you can. ~Paul On Aug 2, 2005, at 11:44 PM, Don Malling wrote: > Anyone have any ideas on how to patch a rust hole in an oil pan w/o > removing the oil pan. It's on a 93 ranger pickup and the manual > says I have to lift the engine up a few inches and remove portions > of the front axle. Seems pretty complicated. I'm hoping there is > another way. > > Don Malling |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Patching an oil pan, Don Malling |
|---|---|
| Next by Date: | Re: rim rusted on utility trailer, Rush |
| Previous by Thread: | Patching an oil pan, Don Malling |
| Next by Thread: | RE: Patching an oil pan, Gerald Brazil |
| Indexes: | [Date] [Thread] [Top] [All Lists] |