On Sat, 28 Sep 2002, Eric wrote:
> Is there a way to increase the air delivery even though the gun can only
> use 1/4"?
I was thinking the same thing about mine. I didn't see a good way to do
it. I was tempted to take the thing apart and *really* find out but good
sense prevailed.
> Next, the documentation states that 90PSI is max working pressure. Can I
> increase that? (Note, I have plenty of PSI and CFM available)
I've read on this list a lit that you can drank up the pressure some. I
always run it about 100 p.s.i. or so because I know there's some pressure
drop across the hose run. A better idea would be a gauge at the gun I
guess.
> Any ideas about getting these lugs off? (FWIW, I was able to remove the
> other sides without to much of a problem. I think that a shop worked on
> this wheel on the truck with a 1" IP wrench and major torque.) I already
> bent a cheater bar on my beater bar. I was thinking heat. Any ideas?
um (and don't take this personally or anything), but what kinda thing is
it you're trying to removw lugs from? I ask, becuase there's an off
chance it might have reverse threads...? but you've already checked for
that, right? not like I've ever done that myself, or anything...
or (and I read this in a magazine once). heat it. then stick a candle on
it, or spray it with lube (I've got pb blaster, dunno how good it is in
comparison to anything else). the wax/lube is supposed to wick up the
threads and help loosen the nut. repeat. a lot.
good luck.
scott
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|