Eric wrote:
> To update you on my impact wrench saga...
>
>
> Now, I have a few questions...
>
> The inlet for the gun is only 1/4" (I'm using 3/8" hoses and couplers up
> to "lead hose" to the gun.(the lead hose is about 24" long and has a
> swivel end.)
>
> Is there a way to increase the air delivery even though the gun can only
> use 1/4"?
No.
>
> Next, the documentation states that 90PSI is max working pressure. Can I
> increase that? (Note, I have plenty of PSI and CFM available)
You can probably go 10-20% over for short bursts.
>
> Any ideas about getting these lugs off? (FWIW, I was able to remove the
> other sides without to much of a problem. I think that a shop worked on
> this wheel on the truck with a 1" IP wrench and major torque.) I already
> bent a cheater bar on my beater bar. I was thinking heat. Any ideas?
Are you absolutely positive that they are not left hand threads?
Mike
>
> TIA
>
--
________________________________________________________________
Mike Sloane
Allamuchy NJ
Email:(msloane@att.net)
Website: <http://www.geocities.com/mikesloane>
Tractor images: <www.fotki.com/mikesloane>
"I'm all in favor of keeping dangerous weapons out of the hands of
fools. Let's start with typewriters and computers."
Solomon Short
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|