Craftsman Club members might want to check out their calendar for this
month. The picture is of a table saw in a half finished area. The back
wall is a seen from the "unfinished" side. Note the spacing on the wall...
The studs are about 8" on center, then about 24" on center for the next 2
then back to 8" on center.
I thought it was pretty funny. I wonder what "Craftsman" did this work?
Or, where is the area that would allow this as code?
Big Smilely ------->>> 8>)
Inch (who is most likely too anal for his own good!)
inch@megageek.com
http://megageek.com/
|