K. M. Lehmann wrote:
> Good deal, good demonstration.
Thanks, Lee.
> I used an 3/4 end cutting wire brush with a 1/4 drill extension in the
> hinge area.
I wanted to go that way, but Home Depot didn't have that stuff! Dang!
I'm SURE the hinge side would've gone a whole lot easier that way, too.
> Your Method of using screws on the window fuzzys is outstanding
> eliminating those stupid staples. I used the #4 countersunk head
> screws 3/8" long I found at the Tru-Value hardware. I am using this
> method on the Wife's Camaro, a job I had been dreading, but is a snap
> with screws.
Plus, when I do my interior and want to cover the stainless trim, I can
remove and replace the fuzzys without any hassle!
:o)
Alan
http://AlanHorvath.com/54chevy/
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|