Crank and input shaft don't turn together when clutch is pressed.
-----Original Message-----
From: AnOld55Truck@aol.com [mailto:AnOld55Truck@aol.com]
Sent: Saturday, March 16, 2002 10:38 AM
To: oletrucks@autox.team.net
Subject: [oletrucks] Reinstalling transmission
Reinstalling transmission in my 55 chevy 1st series. Does anyone
know
if you need to grease the pilot bearing that goes into the end of crank
shaft, before you install the transmission? Does the bearing go on the
transmission spline or into the crank when installing? What does this
bearing
do, being that the crank and the transmission spline turn together?
RON
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|