If you have standard Chevy self-cancelling turn signals the cold wire
from the brake lite switch attaches to one of the 6 wires in the turn
signal switch. Don't remember which one, my schematic is in Houston and
I'm in the mountains in Colorado for a week. If you don't figure it out
by the 17th e-mail me again and I'll check the color for you.
-----Original Message-----
From: S Culver [mailto:sculver@mcleodusa.net]
Sent: Friday, March 08, 2002 4:03 PM
To: oletrucks list
Subject: [oletrucks] Tail lights
I can't believe I'm having to ask this, but I'm stumped. The brake
lights on
the '58 quit working, so I decided to re-wire everything back to the
tail
lights. Now I have tail lights and turn signals, but when I wire in the
brake
lights, it closes the circuit between the two sides, and both sides
blink.
I have 3 wires going to the tail lights. One wire splits and goes to
both
tail lights on the dim side of the bulb. I have one wire to the bright
side
on the left for the left blinker, and one wire to the bright side on the
right
for the right blinker. How do I go from the brake light switch to the
bright
side of both tail lights now without interfering with the blinkers?
Thanks in advance-
Smokey Culver
League City, TX
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|