They say there are to stupid questions.............
How do you intend to install the plate between the outer and inner layers of
the cab?
Blaine Dumkee
1959 GMC 9314
Fort Smith NT
http://www.geocities.com/bdumkee/index.html
-----Original Message-----
From: R Welch <rwelch@bartnet.net>
To: J Forbes <jforbes2@mindspring.com>; Old Trucks List
<oletrucks@autox.team.net>
Date: Thursday, November 01, 2001 10:17 AM
Subject: Re: [oletrucks] 3 Point Seat Belts for 57 3100
>Jim, I think your method only works on a small back window cab - I need to
>go look at mine again, but I don't think it will work for a custom cab
>window.
>
>----- Original Message -----
>From: "J Forbes" <jforbes2@mindspring.com>
>To: "Old Trucks List" <oletrucks@autox.team.net>
>Sent: Wednesday, October 31, 2001 9:40 PM
>Subject: Re: [oletrucks] 3 Point Seat Belts for 57 3100
>
>
>> > Date: Wed, 31 Oct 2001 08:22:00 -0600
>> > From: "R Welch" <rwelch@bartnet.net>
>> > Subject: Re: [oletrucks] 3 Point Seat Belts for 57 3100
>> >
>> > I have not done it yet, but on my 56 TF I was going to investigate
>welding a
>> > nut onto a piece of square tubing long enough so I could hold it from
>the
>> > bottom (and retrieve it if necessary) of the post cavity. I think if
>one
>> > experiments a little with tubing sizes it would be a pretty tight fit
>and
>> > provide some reinforcement - although I'm not sure if its enough. This
>> > method would only require drilling a hole in the post for the seat belt
>> > attachment. If this method is successful, I think one would also want
>to
>> > wrap the tubing with something so it doesn't rattle inside the body.
>Would
>> > be interested in hearing others solution to this problem.
>> >
>> > - -Bob
>> >
>>
>> I have to do this soon also. Here's my plan:
>>
>> First, play around with the belt to see where the upper attatchment
>> should be. Get comfy, and look at other vehicles to see where the belt
>> goes over your shoulder. When you figure out the attatching point,
>> drill the hole for the bolt thru the sheetmetal. Then, make a plate of
>> 1/8" steel, perhaps 4" x 8" or thereabouts. Bend it to fit the curve of
>> the inner panel, centered on the bolt hole (if possible, or offset as
>> necessary). Drill several holes in the sheetmetal, which will be
>> covered from behind by the plate. Drill a hole in the plate, and weld a
>> nut on the backside. Then, put the plate in place behind the
>> sheetmetal, and weld rosettes thru the hols in the sheetmetal.
>>
>> Hopefully you can understand this description! Basically, what happens
>> is that the load from the seat belt attatching point gets spread out
>> over a large area of the sheetmetal, so the bolt won't pull thru in case
>> of accident.
>>
>> Jim F
>> 59s in AZ
>> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|