In a message dated 9/7/00 9:03:16 AM Pacific Daylight Time, gls@4link.net
writes:
> Anyone know of a way to get 6 lug IFS? Obviously, one can't be too
> concerned with originality if one converts to IFS, but just out of
> curiousity.
>
> Regards,
>
> Grant S.
Hey Grant,
I had contacted one of the larger outfits (don't recall which) several
years ago about this..they said they would drill the rotors for any lug
pattern I wanted.
My only concern about it is I'd then be stuck with them for
replacement...and the cost for a new rotor through the company was kinda high
at the time. Dang, wish I could recall who I spoke with...anyways...maybe we
can get one of the manufactures to use a spindle that will work with an off
the shelf 6 lug rotor.
I just hate buying stuff that I cannot go to the local NAPA and get a
replacemnt if needed.
Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|