The TIP plans are drop dead simple. I bought them, but then bought a ready
made cabinet. I had it all planned though. The finished price was going to
be something like $150.00 (all new materials) so you could save a lot, if
you're good at scrounging.
----- Original Message -----
From: "Mike Stone" <mrston@hotmail.com>
To: <oletrucks@autox.team.net>
Sent: Sunday, April 02, 2000 3:59 PM
Subject: [oletrucks] Homemade Blasting Cabinets
> Hello Everyone,
> Has anyone built a sand/media blasting box from a kit or from plans?
I'm
> no woodworker, but I have friends who are, and they think it will be easy.
> If I'm careful about the measurements, etc., can I build something that
will
> work? Does anyone have plans to share for a box big enough for fenders,
> etc.? Any comments would be very helpful. Thanks. I've looked at a couple
of
> catalogs, and I can't afford another "toy" big enough to do the job.
Thanks,
> Mike.
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|