I would have to second Terry on this. Two passes (per board edge) on a
table saw with a fence and dado blade will make the cuts much faster and
cleaner than a router.
As an aside, not to take away anything from the resources section of
chevytrucks.org, I have gone through the archives and combined as much
info as I could gather on bedwood. Not only are there dimensions, but
also finishing information. Check it out and let me know what you think
(and please point out any errors which are entirely mine.)
http://www.chevytrucks.org/users/jeff/bedwood.htm
Jeff Nelson
Paducah, KY
1953 3600
> ----------
> From: Terry White[SMTP:twhite@bcbsal.org]
> Reply To: Terry White
> Sent: Tuesday, February 16, 1999 8:40 AM
> To: oletrucks@autox.team.net
> Subject: Re: [oletrucks] bedwood milled rabbets
>
> Don,
>
> Unless you have some sort of a very reliable straight edged to let
> the router ride against, I would find a friend with a table saw . All
> of the cuts involved, ( if you are referring to the drawing posted
> earlier) can be made with it. Before I went into telecommunications,
> I was a full time woodworker and its still one of my hobbies outside
> of oletrucks..........
>
> Terry White
> 56 3100 SWB
> Harpersville Al
>
> >>> Don Kasbohm <milw8170@dmci.net> 02/15 5:52 PM >>>
> Ok, here's yet another question on this thread. Is there a router bit
> available to cut these into a new board! Thanks!
> Don Kasbohm
> '59 GMC 100 V8
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and
> 1959
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and
> 1959
>
|