I repacked the front hub bearings - no problem. The spindle nut came off
easily. The rear hubs seem to have a different sized axle nut than the front
and
both are on very tight. Can someone enlighten me? My resources say that to
tighten the front you give it a 20 foot pound torque and then back off one
flat. What about the rear?
Regards,
Bill Beer
'62 plus 4 four seater
#4949
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/morgans
|