At 12:14 PM 3/6/99 -0600, Bob Nogueira wrote:
>
>Can someone tell me if the technique for using a Shrinking Hammer ( and
>Dolly ) are the same as a regular hammer and dolly. Do you use a
>shrinking hammer only with a shrinking dolly? Anything special I should
>know before I start pounding this poor panel to mush ?
Bob,
I thought you knew all this stuff!!! :)
I believe it is basically the same. However, I seem to remember reading
somewhere about the technique. Unfortunately, I don't remember what I
read. Start in the middle and work to the outside, or vise versa.
Here are some of the metal working sites I've found, they may be of more
help to you than I can be:
Metal Web News
tbr.state.tn.us/~wgray/index.html
aviator.cwis.siu.edu/john/metalsites.html - John's Metalworking Sites
plains.uwyo.edu/~metal/ - Metalworking
FAQ/Compendium
w3.uwyo.edu/~metal - Metalworking FAQ
www.mindspring.com/~wgray1/
rec.crafts.metalworking - Metalworking news
group
Hope this helps.
John
John T. Blair WA4OHZ email: jblair@exis.net
Va. Beach, Va Phone: (757) 495-8229
48 TR1800 65 Morgan 4/4 Series V
71 Saab Sonett III 75 Bricklin SV1 77 Spitfire
www.team.net/www/morgan bricklin.shel.olsy-na.com/bi
|