At 06:34 PM 1/27/98 -0500, Bob Nogueira wrote:
>-- [ From: Bob Nogueira * EMC.Ver #3.1a ] --
>
snip
> Also a correction of sorts to my last post, I cut the bent section out
>of the fender and while the section which attaches to the fender valance (
>right under the bonnet edge is in fact 16 gauge the part of the fender over
>the wheel is a lighter gauge steel, probably 20 gauge from the feel of it )
>
That's probably the thickness that was left after driving on a lot of
gravel roads. ;)
Jerry Murphy
|