-- [ From: Bob Nogueira * EMC.Ver #3.1a ] --
Hey Moggers, need a favor from some one with a Drophead Coupe.. Could you
measure the distance from the back tip of the aluminum running board strip (
the one with the rubber ) to the body. I need to know the gap from the
body to the strip not the piping to the strip .
Also a correction of sorts to my last post, I cut the bent section out
of the fender and while the section which attaches to the fender valance (
right under the bonnet edge is in fact 16 gauge the part of the fender over
the wheel is a lighter gauge steel, probably 20 gauge from the feel of it )
Bob Nogueira
1964 Plus four
2962 Plus four DHC
_____________________________________
|