-- [ From: Bob Nogueira * EMC.Ver #3.1a ] --
Fred;
Please do send the article, and I'll send you a brass button which could
serve as a paper weight for postage stamps.
Bob Nogueira
BTW I have filed a complaint against Mc Murray Button Supply of Dallas
with the National Assoc. of Rear Axle Button Manufacturers and Suppliers
for selling cheap Asian knock offs of rear axle buttons.
-------- REPLY, Original message follows --------
> Date: Friday, 19-Sep-97 03:38 PM
>
> From: FPS3@aol.com \ America Online: (FPS3)
> To: Bob Nogueira \ Internet: (nogera@prodigy.net)
> To: MORGANS \ Internet: (morgans@autox.team.net)
>
> Subject: Re: Rear Axle part two
>
> The order is....
> Shims
> Bearing retainer (smaller diameter to press on outer race)
> Brake backing plate
> Thick spacer
> "top hat" for grease seal
>
> Don't forget the OIL seals- inside of the bearings.
>
> If you can download an attached file- I'll send you a bit out of the
Bedside
> Reader that may help explain the procedure for setting the end play
(bearing
> pre-load)
>
> Most (in fact all...) articles that I have read on how to set the endplay-
are
> not quite right.
>
> Fred Sisson
-------- REPLY, End of original message --------
_____________________________________
|