I have a question on 31.2.1 in the rules. It says All roll cage members
having a bend radius > 6inches may NOT be longer than 28in. unsupported.
First of all is there a min. bend radius? And does this rule mean if you
have a bent tube then it needs to have a support attached to it at least
every 28in???
Also in section 31.2.8 it says, A bent tube cannot exceed 32in. between
attachment points. Does this mean 32in from end to end of the tube or 32
inches between tubes attached to the bent tube for support?
Thank you
Nathan Baldwin
Miami University, OH
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mini-baja
|