Does this also mean that studed rod ends will not require safety washers?
James
Question: What ball joints are acceptable under rule 37.4.2?
Answer: After an extensive review by the National Technical Inspectors we
have concluded that Rule 37.4.2, governing ball joints, is confusing.
Effective immediately the Rule is revised to allow the use of any ball joints
or rod ends with studs that have been commercial manufactured.
The Revised Rule is:
37.4.2 Ball Joints
Any commercially manufactured ball joints or rod ends with studs are allowed.
Student manufactured ball joints or rod ends with studs are specifically
prohibited.
Please let us know if you have any questions.
Thank you and I apologize for any inconvenience this may cause.
Jessica L. Cutler
Collegiate Programs Coordinator
SAE International
400 Commonwealth Dr.
Warrendale, PA 15096
Phone (724) 772-4079
Fax (724) 776-0890
jcutler@sae.org
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mini-baja
|