Yeah, that's wrong, The hose should be tucked as much as possible
back into the corner so only about half of the open end should be
visible in the front view. I don't have a picture but someone else
did put one up a while ago showing the correct position for the air
hoses. If I see it again I may post it on my web site. -- Barney
At 11:56 AM 4/7/2012 -0700, David Breneman wrote:
> From: Barney Gaylord <barneymg@mgaguru.com>
> >> It is tough to tke a picture in that area with an assembled
> car. I can tell you that the original bolt for the forward P-clip
> goes through the horizontal air pan in the outboard corner near the
> body mount. You need to form the hose to fit first, push it onto
> the top connector pipe, then position the P-clip and install the
> bolt last. It is a lot easier if the grille is not in place at the
> time. That bolt has given me so much grief over the years that I
> drilled another hole inboard from the hose and turned the P-clip
> around to make life easier.
>
>
>This is the way mine was done, at the bottom of the page linked
>below. I seem to remember Barney commenting on this a few years
>ago, but I don't remember if he said if it's correct or it's somehow
>wrong... http://tildebang.com/mg/index34.html
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/mgs/mgs-archive@autox.team.net
|