| Subject: | [Mgs] Stripped valve adjuster screw |
|---|---|
| From: | paul.hunt1 at blueyonder.co.uk (Paul Hunt) |
| Date: | Sun, 14 Aug 2011 09:46:44 +0100 |
| References: | <4e468fe8.47c5e00a.27a1.398f@mx.google.com> <592620.9320.qm@smtp103.sbc.mail.mud.yahoo.com> |
And bear in mind that if it is the nut part of the adjuster that has been damaged you may get resistance as you screw the adjuster downwards as well. ----- Original Message ----- > The ball end is larger than the thread, so it will not come out the top, > must go out the bottom. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Mgs] Stripped valve adjuster screw, Paul Hunt |
|---|---|
| Next by Date: | [Mgs] Automotive News Uses MGB, Norm 2Bs |
| Previous by Thread: | Re: [Mgs] Stripped valve adjuster screw, Paul Hunt |
| Next by Thread: | [Mgs] Automotive News Uses MGB, Norm 2Bs |
| Indexes: | [Date] [Thread] [Top] [All Lists] |