I have seen this done successfully a few times over the years. It if far from
a optimal solution but I have seen it work on American Motors, Peugots, and
Volvos.
If the bearing journal is rough try this. Get a roll of fine emery cloth. Tear
off about 36 inches, and then a strip about 3/8" wide from that piece. Wrap
the strip 1 full time around the crank and polish away.
Good luck
Rick
Sent from my iPhone
On May 2, 2011, at 10:54, WSpohn4 at aol.com wrote:
> Don't even waste the time unless you measure the journals and make sure
> they aren't tapered or ovalled. Otherwise it will just be wasted time and
> money.
>
> Bill
>
>
> In a message dated 5/2/2011 10:46:25 A.M. Pacific Daylight Time,
> mgbnutt at aol.com writes:
>
> I realize that "flying in" new bearings is an 'iffy" procedure at best,
> but
|