The rear bearing is a press fit.
I can't visualize it now (it's been a long time) but you can space out the
drive flange with something and use an impact wrench on the axle nut to pull
the axle and bearing.
--
Stephen West-Fisher
N4IK
-----Original Message-----
From: mgs-bounces@autox.team.net [mailto:mgs-bounces@autox.team.net] On
Behalf Of Councill, David
Sent: Sunday, April 17, 2011 2:55 PM
To: mgs@Autox.Team.Net
Subject: [Mgs] Tale of the rear axle
I am partway into a rear axle thrust washer replacement. I am now at the
stage
of trying to pull out one of the half shafts.
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|