In the dark and the dirt, this can be a hassle. Unfasten the slave
cylinder, then access to the hose ends is a bit easier. You might need a
Whitworth adjustable wrench for this job. Left-handed ones are best.
Bob
On Wed, 17 Mar 2010 18:34:07 -0600 "Councill, David"
<dcouncill@msubillings.edu> writes:
> I am battling the infamous slave cylinder hose and it seems a
> tighter
> fit in the Mk1 MGB (64). I am trying to remove it but am trying to
> figure out the tool I need. I lowered my largest crowfoot wrench
> (3/4")
> to gauge the size of the nut and its too small. Does anyone know
> the
> size wrench I need for this? And maybe the preferred tool for
> removing
> and replacing?
>
>
>
> David Councill
>
> 64 B
>
> 67 BGT
>
> 72 B
____________________________________________________________
Criminal Lawyer
Criminal Lawyers - Click here.
http://thirdpartyoffers.juno.com/TGL2141/c?cp=qMv-twlqUGzT85XwYCVBFAAAJ1CFcZuYg3ZrSi-zVv-uUL-FAAYAAAAAAAAAAAAAAAAAAADNAAAAAAAAAAAAAAAAAAAiFgAAAAA=
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|