Hey Steve, IMHO you will need to remove the carb(s) from the manifold, take off
the bottom plate, (4 screws), and just replace the float, valve assy., (use
vitron tipped), and, in my case, the shaft that holds the float.? I did both
carbs as they are the same vintage.? It is a simple procedure once the parts
are on hand.? Oh yeah, buy new bottom gaskets too.? Regards, Tom
-----Original Message-----
From: Daybell7@aol.com
To: mgs@autox.team.net
Sent: Thu, Jul 16, 2009 12:21 pm
Subject: [Mgs] SU-HIF Problem
Greetings MG'ers,
I have gas flowing from the valve cover vent pipe of my front carburetor
(SU-HIF). Is this the float needle valve failing to seal? Can I fix
without rebuilding the carb?
Thanks in advance.
Steve Hughes
Gainesville, FL
1972 MGB
1968 MGB-GT
**************S T R E T C H your technology dollars with great laptop
deals from Dell!
(http://pr.atwola.com/promoclk/100126575x1223081712x1201714210/aol?redir=http:%2F%2Faltfarm.mediaplex.com%2Fad%2Fck%2F12309%2D81939%2D1629%2
D5)
You are subscribed as tmcnam4510@aol.com
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|