I was going to replace the seal on the windshield pillar which meets
the vent window frame. After struggling with the old one a bit, I
discovered the aluminum retainer INSIDE the seal cavity attached with
two screws. So, one installs the new seal, slides the retainer
inside, puts two HOLES in the new seal, install screws and puts
sealant on the holes. I can't imagine the need for for this. I think
the channel retainer will be quite adequate. What have others done?
Allen Hess
71 MGB
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|