In the July/Aug '99 issue of MGB Driver there was a reprint of Leyland's
MGBGT V8 shop manual supplement that showed how to install the transmission
crossbrace WITHOUT needing to cut any holes in the crossbrace.
Mark
Corunna, ON
73 MGBGT
76 TR7
80 Spitfire 1500
Dan DiBiase
<d_dibiase@yahoo.com> To: Ed Woods
<fogbro1@comcast.net>, mark.jones@exxonmobil.com
cc:
Mgs@autox.team.net
Subject: Re: [Mgs]
transmission switches
06/19/2008 09:49 AM
Ed, have you made the modification to the transmission crossmember that
allows you to tighten the bolts on the transmission? Basically,
you drill 2 holes through the crossmember to allow you to pass a socket
through to the bolts.
Dan D
Central NJ USA
'76 MGB Tourer - Driver - Engine Surgery In Progress...
'65 MGB Tourer Project - Yep, Still Is....
NAMGBR #5-2328
http://dans65b.blogspot.com/
http://dansautoblog.blogspot.com/
http://mywebpages.comcast.net/dibiase/Working_MG_Gallery.html
----- Original Message ----
From: Ed Woods <fogbro1@comcast.net>
Mark,
Thanks for the drawings of the transmission mounting and remote shifter
assembly.
The step by step removal/replacement instructions for the transmission
mount/X member were invaluable, especially the part about starting the rear
transmission bolts before offering up the X member.
Ed Woods
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|