Actually the way we used to measure them was between the welds on the
main tube. That way you only need the main tube, not the whole assembly.
Short 20.25"
Med. 21.25"
Long 22.25"
The standard way of measuring, as shown below is from flange face to
flange face with the sliding joint fully compressed.
Kelvin Dodd
> -----Original Message-----
> From: Paul Osborne [mailto:paul@ece.rochester.edu]
> Sent: Tuesday, September 25, 2007 5:23 AM
> To: Dodd, Kelvin
> Cc: mgs@autox.team.net
> Subject: RE: [Mgs] MGB O/D Driveshafts
>
> Thanks to all for the info, but, from where to where is the
measurement
> taken?
> paul
>
> >I made up simple diagram to understand this many years ago.
> >
> >All you have to remember is 1", because the extra .125" is too hard
to
> >read.
> >
> >It is a bit counter intuitive though as the 3 sych 4 spd is longer
than
> >the 3 synch OD box.
> >
> >
> >3 synch 4 spd - Early Banjo short 30"
> >3 synch OD - Early Banjo Med. 31.125"
> >3 synch OD - Saulsbury Long 32"
> >4 synch 4spd/OD - Saulsbury Med. 31.125"
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|