To: | "Paul Hunt" <paul.hunt1@blueyonder.co.uk> |
---|---|
Subject: | Re: Radiator cooling fan thermostat removal |
From: | "Simon Matthews" <simon.d.matthews@gmail.com> |
Date: | Wed, 20 Sep 2006 10:30:00 -0700 |
Could it be related more to temperature? Above the water level the temperature could be much higher. On 9/20/06, Paul Hunt <paul.hunt1@blueyonder.co.uk> wrote: > Hmmm, well, the pressure will only rise to the level of the cap, which could > occur from reasons other than steam pockets. Logic dictates that the > grommet should *at least* be capable of resisting cap pressure, but maybe > that is where it falls down. |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: type plate on heater MGA 1600 MKI, Paul Hunt |
---|---|
Next by Date: | Re: Clutch slave piston, MGA early MGB, Hans Duinhoven |
Previous by Thread: | Re: Radiator cooling fan thermostat removal, Paul Hunt |
Next by Thread: | Re: heater valves, Thomas L. Burgin |
Indexes: | [Date] [Thread] [Top] [All Lists] |