I drilled a small hole in the end of the nylon bushing, turned in a sheet
metal screw and yanked it out with vicegrips on the screw.
HTH
Jim L
74 CB
74 RB
----- Original Message -----
From: "Jeremy Loukinas" <Sunadmin@adelphia.net>
To: <mgs@autox.team.net>
Sent: Thursday, March 31, 2005 12:33 AM
Subject: Nylon bear/seal removal Midget Master Cylinder
>I am in the process of rebuilding my Midget master cylinder. 73 GAN5 car
>...
>
> Once I removed the MC from the car I compressed the Spring and removed
> the Spirolox ring allowing me to see the Nylong Guide Bearing/Seal. I
> removed the Circlip but How do you remove this Nylon seal?? I am reading
> a Haynes manual and it says :
|