If the rivet holds some kind of fastener it should be at the bottom. The
headlamp bowl should have the mating part of the fastener, often a spring
clip, also at the bottom. The adjustment screws for the aim should be at
the top and left on both headlights. If this is not the case then someone
may have installed replacement mounting flanges upside-down, or maybe they
have contrived to get the lens and glass in the frame upside down.
Or is the main and low-beam wiring simply reversed?
PaulH.
----- Original Message -----
From: "Mark Lennan" <mlennan@crankyrobots.com>
To: <mgs@autox.team.net>
Sent: Wednesday, November 19, 2003 4:09 PM
Subject: Headlight trim rings
> Are the two rivets on the headlight trim ring (that hold the alignment
> clip) supposed to be on the top of the ring or the bottom?
>
> I recently bought some H4 units and after installing (lining up the
> tabs on the headlight with the grooves of the housing) I found that my
> low beams pointed up and my hi-beams pointed down...
|