Clearly you have purchased a set of Australian bulbs...
Bill
----- Original Message -----
From: "Mark Lennan" <mlennan@crankyrobots.com>
To: <mgs@autox.team.net>
Sent: Wednesday, November 19, 2003 11:09 AM
Subject: Headlight trim rings
> A quick question:
>
> Are the two rivets on the headlight trim ring (that hold the alignment
> clip) supposed to be on the top of the ring or the bottom?
>
> I have reason to believe that (somehow...) the headlights housings are
> installed improperly. My rivets are on the top of the rings when
> installed.
>
> I recently bought some H4 units and after installing (lining up the
> tabs on the headlight with the grooves of the housing) I found that my
> low beams pointed up and my hi-beams pointed down...
>
> It appears that everything can only install one way but something is
> amiss. A response from the MGB Experience BBS stated that the rivets
> point down, but I cannot install with the rivets down because the large
> holes in the headlight well (that accept the adjustment screw sticking
> out, are only on the top, left and right side of the headlight hole.
>
> Figured I'd start with how it's supposed to look. Rivets up or down or
> left or right?
>
> Thanks, all!
>
> Mark Lennan
> 79B
|