Depends where the leak is. The coolant only needs to be below the leak for
you to be able to solder it. But if it is a seam that is leaking past
experience has shown that unless you do a proper job by completely removing,
cleaning up and resoldering the section the seam is likely to open up again.
----- Original Message -----
From: "Paul Root" <proot@iaces.com>
To: "MonteMorris" <mmorris@nemr.net>
Cc: "Bob D." <bobmgtd@insightbb.com>; "mgs" <mgs@autox.team.net>
Sent: Friday, May 16, 2003 1:17 PM
Subject: Re: Unintentional Off-Road Excursion
> > Dumb question: Can you solder the leaks while there is coolant in the
> > radiator, or do you have to drain it?
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|