Hi Bob,
Suggest you see where the mark is when the points open. Put a
pointer there for future reference. In fact, I'd put a timing light on
all cylinders in order and see if someone put a reference mark there.
Cheers,
CR
engl wrote:
> The timing mark turns is at about 10 o'clock (facing the engine) when the
> rotor is at #1 - no timing marks there !
>
> Bob
>
>
>
> |-----Original Message-----
> |Subject: RE: New MGB - A couple of questions
> |
> |
> |Telewest(PH)
> |
> |Thanks for the response. A couple of more questions then:
> |
> |- what is the right size pulley for the engine? and how much clearance
> |should there be between the pulley and the subframe?
> |
> |- yes there is a small timing mark on the pulley. Not sure where it's at
> |when the rotor arm is at #1, but I'll check. And yes, the engine does run!
> |
> |Thanks again for your help.
> |
> |Bob
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|