Long term effects of ArmorAll on rubber?? I have no idea. But it should be
slick enough to do the job.
Larry
On 4/8/01 10:55 AM, "JERTIGGER2@cs.com" <JERTIGGER2@cs.com> wrote:
> In a message dated 4/8/01 8:08:52 AM Eastern Daylight Time,
> macy@bblmail.psycha.upenn.edu writes:
>
> << One thing I found out AFTER I did this. You may want to put something like
> silicone grease into the glass channel of the rubber gasket before assembly.
> Like I said I used soap. If you get water into that channel the plastic, or
> whatever is in the glass sandwich, will begin to fog if water gets into the
> channel. Mine is :-(
>
> Larry
>
> On 4/7/01 5:40 PM, "JERTIGGER2@cs.com" <JERTIGGER2@cs.com> wrote:
>
>> I am about to embark on the journey of ordering and replacing a new wind
>> screen for my 73 Midget.
>>>>
> Rather than soap how about armerall(spelling?)
>
> Jerry
>
Larry Macy
78 Midget
Keep your top down and your chin up.
Larry B. Macy, Ph.D.
macy@bblmail.psycha.upenn.edu
System Manager/Administrator
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104
Ask a question and you're a fool for three minutes; do not ask a question
and you're a fool for the rest of your life.
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|