Lawrie,
Pushed long 3/8" drive extensions (Snap-Ons are real skinny) thru the
plug holes, after wrapping three turns of electrical tape around the the
extensions where they contacted the threads. Pushed down smoothly. Head
tilted. Yippee!
I suppose that one could put plug sockets with extensions on the end
plugs and do the same thing by pushing from the other side. Doesn't
really take much force since the head is narrow. Could use old head
studs inserted part way into the head, too.
How do you do it?
CR
Lawrie Alexander wrote:
>
> I can see where this technique would provide extra leverage to remove the
> head, but how did you protect the spark plug hole threads from damage?
>
> Lawrie
|