I installed an ANSA recently to the stock front pipe. Once you have the
pipes connected, then you have to fiddle for a while with the rear-most
hanger, but it WILL fit. In fact, I had fabricated a plate with four holes
to connect the stock with the Ansa bolts (at the rear), but then they lined
up on the third try. It's a good work out, but you'll get it!
I had to install a spacer for the middle bracket since the ANSAs bracket was
about 1 1/2 " too far to the rear of the stock hanger.
Hope this helps.
Dan
73 B
-----Original Message-----
From: Don Walton <dhw@atomic.net>
To: mgs@autox.team.net <mgs@autox.team.net>
Date: Wednesday, July 15, 1998 10:09 PM
Subject: Ansa Question and air filter question
>Hello all, Today I did the switch from Stromberg to SU on my 77B. I am
>trying to install an Ansa exaust system to the stock front pipe. I
recieved
>no instructions on how to mount the rear muffler to the stock hanger, and
>was wondering if anyone could point me in the right direction on the rear
>mount.
> The air filter question is this, does anyone make an air filter thin
>enough to fit between the servo and the rear SU carb ? If not, what mods
>must be done to make one fit ? TIA Don Walton in NC
>
|