Hi!
I just purchased a 1977 MGB and while investigating a pull under braking,
I discovered that the drivers rear line had been smashed leaving a nice
crimp.
I've been looking for the line and was about to buy a straight piece from
Victoria and bend it myself. Then this post! Thanks!
I called, they only have tubes up to 1974. Should I order this or make my
own? I don't see any reason why it won't work, suggestions?
Thanks in advance!
-craig
On Fri, 10 Jul 1998, Robert Allen wrote:
>
> There is as place that can bend you a set to factory specifications.
> Relative to the cost of materials it seems a little high but, of course, it
> depends how much scrap you would need before you get proficient.
>
> The place is:
>
> Classic Tube
> 80 Rotech Drive
> Lancaster, NY 14086
>
> 1-800-882-3711
>
> http://www.classictube.com
>
> Bob Allen, Kansas City
> "I always wanted to be somebody, but I should have been more specific." --
> Lily Tomlin and Jane Wagner
>
|