I think you better ignore this previous location - it is for s 77B, and the
tonneau covers are definately different. I have a good '67, and I measured
it. I have 4 measurements for you - my car is left hand drive (US), if
yours is right hand, I'd assume a mirror image. All of these measurements
are from the tips of the studs. From the left hand stud to the right hand
stud should be 44 inches. From the left hand stud to the center stud is 21
1/4". From the right hand stud to the center stud is 23 1/4". From the
right hand bolt of the boltdown fixture to the center stud is 4". I hope
you're good with geometry.
> On a 77 B the stud is located about 5/8" below the right bolt that
>holds the tie bar on the windshield. It is not a normal stud but is held
>by by 2 screws.
>...Arto
>
>
>
>On Sun, 27 Jul 1997, bill and penny meyer wrote:
>
>> AM REBUILDING A '67 BONDO QUEEN. HAVE RE-COVERED THE DASH AND CANNOT
>> LOCATE THE MOUNTING HOLES FOR THE CENTER TONNEAU STUD. COULD
>> SOMEBODY PLEASE PROVIDE MEASUREMENTS FROM THE WINDSCREEN BOLTDOWN
>> FIXTURE OR WHATEVER??
>> ALSO, WHAT ARE THE PROPER LOCATIONS AND CONFIGURATION (B
>> SINGLE STUD WITH NUT OR TWO SCREW TYPE) FOR THE SIDE/CORNER DASHTOP
>> TONNEAU STUDS??
>> FEELING QUITE EMBARRASSED
>>
>>
>
>
>
Phil Bates
58 MGA
67 MGB
75 Jaguar XJ12C
66 Land Rover
52 MG TD replicar (VW)
86 Peugeot 505 Turbo Gle
86 Honda Accord LX-i
|