--- On Wed, 6 Nov 1996 22:39:22 PST "David F. Darby" <dfdarby@juno.com>
wrote:
>Someone figure out how to make a "round" drive, because that's about the
>only configuration missing.
>
>David F. Darby
>Ozark Highlands, Missouri
>
-----------------End of Original Message-----------------
It's already been done, haven't you seen one of those bolt extractors that
use use with a ratchet to back out studs with broken off heads?
:)
-------------------------------------
John Steczkowski
Senior Manager
PSW Technologies
512-343-6666
stecz@pswtech.com
http://www.pswtech.com/~stecz
http://www.pswtech.com
11/7/96 3:33:43 PM CT O-
|