Is that per wheel or per setup? i.e. $300-500 X 4?
----------
From: mgs-owner[SMTP:mgs-owner@autox.team.net]
Sent: Wednesday, August 14, 1996 5:30 PM
To: Randyr
Cc: FunE4MG; mgs
Subject: Re: Wheels
In a message dated 96-08-14 13:19:24 EDT, Randyr@starwave.com (Randy Rees
(Starwave)) writes:
<< yes!!! and I really don't care for the minilites. I wonder if a really
good wheel repair shop or machinist could graft the center hub from a set
of
wires onto a set of aluminum wheels? Any machinists out there? >>
Sure, lots of them, and anything is possible, How much do you want to
spend?
Ever get a good look at a Twin Cam wheel? Looks a lot like a standard
steel
wheel (a bit wider and heavier) bolted to a spline hub adapter. I trust
that
the splines don't match the standard wire wheel splines, but the concept
is
there.
Just out of curiosity, how many of you would pay say $300 to $500 each
for
splined hubs to fit your wire wheel car that you could bolt a standard
wheel
onto? If there's enough interest, I think I could arrange it.
Barney Gaylord -- 1958 MGA
|