In a message dated 96-08-14 13:19:24 EDT, Randyr@starwave.com (Randy Rees
(Starwave)) writes:
<< yes!!! and I really don't care for the minilites. I wonder if a really
good wheel repair shop or machinist could graft the center hub from a set of
wires onto a set of aluminum wheels? Any machinists out there? >>
Sure, lots of them, and anything is possible, How much do you want to spend?
Ever get a good look at a Twin Cam wheel? Looks a lot like a standard steel
wheel (a bit wider and heavier) bolted to a spline hub adapter. I trust that
the splines don't match the standard wire wheel splines, but the concept is
there.
Just out of curiosity, how many of you would pay say $300 to $500 each for
splined hubs to fit your wire wheel car that you could bolt a standard wheel
onto? If there's enough interest, I think I could arrange it.
Barney Gaylord -- 1958 MGA
|