Rick:
The original SU pump works just fine for a carbureted 3.5L. I've gone
the same route of multiple different after market pumps, but have come
back to the original. Just a thought.
The kicker for me was looking at a UK built V8 powered Group B Rally MG
Metro. They had pulled out the Rover derived V6 and installed a V8 in a
very professional manner. With all of the pumps available, they chose a
good ole' SU one to keep it fed.
Kelvin Dodd
> -----Original Message-----
> From: mgb-v8-bounces@autox.team.net
> [mailto:mgb-v8-bounces@autox.team.net] On Behalf Of Rick Huber
> Sent: Tuesday, October 14, 2008 6:38 PM
> To: mgb-v8@autox.team.net
> Subject: [Mgb-v8] Fuel Pump Woes
>
> Hi V8ers,
> I have a 75 MGB Rover 3.5 V8. I've been running the Borg
> Warner EP-10 fuel pump for 9 years, mounted on the underside
> of the panel just in front of the gas tank, just above the
> rear axle, so fuel pump above the tank. In July, the fuel
> pump quit. I called several parts stores looking for the BW
> EP-10, which is not made anymore, but Napa cross referenced
> it to something they carried. I don't have the box anymore,
> but the label on the pump is Carter with two numbers,
> P61296S, and 08C04A. Swapped pumps and the new one lasted
> about 50 miles. Checked everything in the system before
> determining that indeed the brand new fuel pump was bad,
> wouldn't even pump gas out of a jar on the floor of the
> garage after removing it. Took it back to Napa and got
> another new one, assuming the pump was bad. Changed inlet
> hose, connections, blew back into the tank, put on another
> upstream filter.
> Second Napa pump lasted about 300 miles, one drive past a
> weekend trip with the club from Baton Rouge to Natchez for
> the Natchez/Vidalia car show.
> Talked to a few people, and someone suggested a different
> brand, different store, so I went to Auto Zone and got the
> Airtex E8016S. Got home and took it out of the box, and it
> looks identical to the Carter.
>
> I've put it on the car, but I have a feeling it's only going
> to last a very short time, so I'm ready to try something
> different. Is the problem that these new pumps won't suck
> gas out of the tank when mounted above the tank?
> Can I get a different pump that I can mount in the same
> location that will suck gas out of the tank? I can change
> the mounting location of the Airtex pump, but that sounds
> like a pain if I could just swap the pump again in the same
> location. I've heard of the little square pumps - someone
> said to get the low pressure version for a carburetted car.
> Anybody with a similar experience? Any solutions?
>
> Thanks,
>
> Rick Huber
> Safety Faster with a V8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgb-v8 mailing list
Mgb-v8@autox.team.net
http://autox.team.net/mailman/listinfo/mgb-v8
|