Assuming you are going to use this with a Buick 215/Rover engine, the only
bell housings that will work are a GM Buick/Olds 215 which is very round
with 2 short ears that are square ended, or the TransDapt which is the same
except it is a full 360` bell. With the GM, there are 3 bolt patterns, 4
holes almost a square pattern which won't work- 3 speed tranny- 4 holes in a
wide pattern with 1 pair wider than the other- a 4 speed trans-, & finally
an 8 holer which is a dual pattern 3 & 4 speed.
Send a picture showing the bolt pattern.
Jim Stuart
-----Original Message-----
From: owner-mgb-v8@autox.team.net [mailto:owner-mgb-v8@autox.team.net]On
Behalf Of Automobile Information
Sent: Saturday, April 17, 2004 5:28 PM
To: mgb-v8@autox.team.net
Subject: trans , bellhousing questions
I have what is supposed to be a 5-speed T5 out of a 1990 Camaro with a 305
V8. I bought a GM bellhousing that has the two different size mounting
options ( 4 holes and four threaded holes). None of these line up with my
T5. the bellhousing will not even reach the lower mounting holes. Any
suggestions as to what I have. Tags on the trans are unreadable but, I
believe it to be WC T5. If anyone can help I can send photos.
Mike
Denver, CO
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|