To: | "James J." <m1garand@speakeasy.net> |
---|---|
Subject: | Re: Crank journal surface |
From: | "T. S. White" <tswrace@pacbell.net> |
Date: | Sun, 21 Dec 2003 10:00:10 -0800 |
Cc: | mgb-v8@autox.team.net |
References: | <BC08B9F0.1BFB%junkman923@earthlink.net> <3FE351FE.000012.03400@james-jewell.ipo.gov> <3FE4721D.FADC5890@pacbell.net> <3FE49419.6090807@speakeasy.net> <002f01c3c742$aca884c0$f3422840@ejrussell> <3FE52D5C.90305@speakeasy.net> |
Reply-to: | "T. S. White" <tswrace@pacbell.net> |
Sender: | owner-mgb-v8@autox.team.net |
James, the pin pricks will probably not be a problem. Maybe blemishes from the nitrating. If you can't feel them with your finger nail then they won't hurt your bearings. The .001" tolerance is actually what is used for align honing the main journals. So if you are within that tolerance you should be fine. -- Best Regards, Tom /// /// mgb-v8@autox.team.net mailing list /// Send admin requests to majordomo@autox.team.net /// Send list postings to mgb-v8@autox.team.net /// Edit your replies! If they include this trailer, they will NOT be sent. /// |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Looking for a lonely 300 head, T. S. White |
---|---|
Next by Date: | Re: Looking for a lonely 300 head, Eric J Russell |
Previous by Thread: | Crank journal surface, James J. |
Next by Thread: | New Aftermarket Buick/Rover heads (not Wildcat), JJJ |
Indexes: | [Date] [Thread] [Top] [All Lists] |