Are you sure you don't mean 6 x 1 mm, Dave?
> -------Original Message-------
> From: Dave & Liz DuBois <firstname.lastname@example.org>
> Subject: Re: tappet cover studs
> Sent: 09 Sep '06 13:54
> A couple of 8 X 1mm nuts run down on the stud and jammed together should
> back them out. If the nuts slip on the stud before the stud turns,
> apply heat to the bottom of the stud. If it isn to entirely necessary
> to remove the studs, then leave them in and clean up the threads with a
> 8 X 1mm die.
> Good luck,
/// unsubscribe/change address requests to email@example.com or try
/// Archives at http://www.team.net/archive/mg-t