[Top] [All Lists]

Re: tappet cover studs

Subject: Re: tappet cover studs
From: Dave & Liz DuBois <>
Date: Sat, 09 Sep 2006 14:54:36 -0700
A couple of 8 X 1mm nuts run down on the stud and jammed together should 
back them out.  If the nuts slip on the stud before the stud turns, 
apply heat to the bottom of the stud.  If it isn to entirely necessary 
to remove the studs, then leave them in and clean up the threads with a 
8 X 1mm die.

Good luck,

///  unsubscribe/change address requests to  or try
///  Archives at

<Prev in Thread] Current Thread [Next in Thread>