Terry,
1/2" sounds a little excessive but the first priority is the door fit.
What happens to the door fit when you secure the tub to the chassis?
Use as many shims as you need to make sure the doors fit. And there is
always the possibility that the chassis is a little tweaked.
Regards,
Charles Hill
TATERRY@aol.com wrote:
>Gents, I'm preparing the shims for the body tub so I can bolt it down prior
>to trial fitting wings etc. The 4 mounting points along the two sides of the
>tub rest comfortably on the frame horns but the two rear most mounting points
>are about 1/2" off the frame horns. Were there extra thick shims at that
>point, or should I pull the tub down to the frame with the bolts??
>
>Tnx
>Terry in Oakland
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|